Explore 36 Engineering Areas

Units, statics, mechanics of materials and engineering fundamentals.

Shafts, joints, component sizing and mechanical design checks.

Ratios, tooth geometry, loads, efficiency and gear-train design.

Bearing selection, life, lubrication and load analysis.

Helical, leaf and torsion spring geometry, stress and rate.

Preload, joint strength, thread engagement and bolted-joint design.

Weld sizing, weld groups and static or fatigue loading.

Pressure containment, piping geometry and flow support calculations.

Bending, shear, deflection, section properties and structural response.

Fatigue criteria, stress concentration and failure theories.

Flow, pressure loss, velocity, head and hydraulic behavior.

Pump power, system curves, operating points and pump selection.

Compressed-air force, consumption, pressure and actuator sizing.

Torque, speed, motor sizing and power-flow calculations.

Belt speed, tension, power capacity and pulley calculations.

Sprockets, speed ratios, chain pull and service-factor checks.

Conduction, convection, radiation and heat-exchanger calculations.

Energy balance, properties, cycles and state-change calculations.

Cooling loads, psychrometrics, air systems and refrigeration cycles.

Cutting speed, feeds, power, material removal and tool-life estimates.

Bend allowance, flat pattern, forming and press-brake calculations.

Solidification, shrinkage, allowances and forming loads.

Fabrication mass, weld processes, layouts and workshop estimates.

Material properties, selection, mass and condition-dependent behavior.

Fits, limits, tolerance stack-up and geometric dimensioning.

Linkages, kinematics, actuator force and mechanism geometry.

Natural frequency, response, balancing and dynamic loading.

Friction, lubrication, wear and contact mechanics.

Work, energy, efficiency and energy-storage calculations.

Torque capacity, energy dissipation and thermal checks.

Energy fluctuation, inertia and speed variation calculations.

Engine displacement, power, performance and cycle calculations.

Vehicle tractive effort, drivetrain gearing and thermal-mechanical estimates.

Vehicle mechanics, braking, suspension and driveline calculations.

Conveyors, lifting, process equipment and machinery sizing.

Unit conversion, mass estimates, rates and manufacturing cost drivers.